Difference between revisions of "Bat Box"
Jump to navigation
Jump to search
| Line 42: | Line 42: | ||
==Workshop July 2019== | ==Workshop July 2019== | ||
| − | <gallery mode=packed-hover heights= | + | <gallery mode=packed-hover heights=600px> |
File:BATBOX1.PNG | File:BATBOX1.PNG | ||
File:BATBOX2.PNG | File:BATBOX2.PNG | ||
Revision as of 08:17, 12 July 2019
| Bat Box | |
|---|---|
 | |
| Primary Contact | Danspencer101 |
| Created | 23/06/2019 |
| Completed | 23/06/2019 |
| Status | Complete |
| Type | Workshop Activity |
| QR code | |
I had a go at making a Bat Box from plans on the Nottinghamshire Wildlife Trust website.
The wood (6" x 1" x 1200mm) was obtained from Harlow Bros. It can be brought in 4m-ish lengths for around £7. They cut it down for free into three manageable lengths that would fit into my car.
Plans from the Wildlife Trust Website
Method
The method of manufacture is as follows:
- Mark out the wood with a marker pen or pencil
- Table Saw to do the majority of the cuts.
- For the side pieces with angled tops, I used the Sliding Mitre Saw.
- Hand Miter Saw to do the 1mm deep bat ladder on the back piece.
- Impact Driver to screw everything together.
- Laser Cutter to engrave logos.
- Seal gaps with wood glue.
Gallery
Marking out the cuts
Marking out the cuts
The finished bat box
The finished bat box
Workshop July 2019
Also available as a PDF File:BatBox Workshop.pdf