Difference between revisions of "Bench Pillar Drill"

From Nottinghack Wiki
Jump to navigation Jump to search
(defunct test)
(defunct test)
Line 12: Line 12:
 
|defunct=yes
 
|defunct=yes
 
}}
 
}}
 
 
This is a 5-speed, 250W unit from Wickes
 
This is a 5-speed, 250W unit from Wickes
  

Revision as of 17:12, 19 February 2019

Bench Pillar Drill  (defunct)
Bench pillar drill 01.jpg
Manufacturer Wickes
Model
Obtained
Location [[In Storage

Hackspace 2.5]]

Team Tools
Induction Required No
Booking {{{booking}}}
Status Defunct
Tools:   all pageslistPower ToolsBroken tools     {{}}

[[Category:Tools and Equipment in In Storage

Hackspace 2.5]]

This is a 5-speed, 250W unit from Wickes

Mounted on a piece of heavy kitchen worktop to provide a stable base. This tool is now stored in Hackspace 2.5, The blue Record pillar drill, purchased as part of the pledge drive, has been brought upstairs to replace it.

Chuck capacity 12mm / 1/2"

Normally set to the middle speed range - adjust it by pulling forwards the motor using the handle at the rear, locking it in this position using the securing lock on the right-hand side. Squeeze the spring as tight as possible using one hand before locking with the other.

It is easiest to first slip the belt up or down the stack of reducing pulley sizes, then adjust the other (increasing size) end to arrive at the correct position. Then release the locking screw to allow the motor to return to its normal running position, making sure that the belt is seated squarely in the pulleys and is not twisted. Close the belt cover and check that the drill runs quietly and smoothly (as far as possible) before using it. Check for a twisted or damaged belt if this is not the case.

Problems

Like many similar low-cost drills, the accuracy of the chuck is not brilliant.

The depth stop is broken.

Repaired, as far as possible. Note that the stop causes the drill axis to wander - it's best to use the depth stop as a visual cue rather than a mechanical limit.

Replacement belt type K28 from Solent Tools [1]

After misuse of worn and inappropriate chuck keys, the original chuck became damaged (Jan2013), and it became more and more difficult to tighten securely, causing consequent damage to drill bits. A replacement chuck (physically larger, though with the same drill-size range) has now been fitted. (Apr2013 Dclarke (talk))

Once again, the depth-scale has become detached, and the depth stop broken.

Bench pillar drill 02.jpg Bench pillar drill 03.jpg