Counting Poo/Ideas

From Nottinghack Wiki
Jump to navigation Jump to search


This page is for logging and discussing ideas for how to improve and progress the project.

Multiple Sensors, One Aggregator

Added by JF, 13Jan14

Consider designing the data-gathering controller to accept input from multiple latrines. When several latrines are located together, this may reduce the financial and power costs, relative to one controller per latrine.

I don't know how often this would be useful. Are there areas where multiple pits are close enough to allow this? Would it require a low-power short-range wireless network of sensing nodes instead of wires? If so, does that make it too expensive/complex?

Design pit sensor as "remote node"

Added by JF, 13Jan14

Instead of just a "dumb sensor" in the pit, incorporate a small microcontroller (e.g. ATTINY85) into the design.

For a small extra cost, this adds the capability to re-program/re-configure remotely without lifting the pit slab. Also reduces analog signal path lengths, which is always a good thing.

It also means that the design of the data collector can be generic, as the interface to each sensor will be the same regardless of its actual implementation. The interface can be a simple serial protocol.

Observe this simple diagram: