Difference between revisions of "Donkey Saw"

From Nottinghack Wiki
Jump to navigation Jump to search
Line 28: Line 28:
[[File:Donky Saw Rating Plate.jpeg|thumb|left|400px|Rating Plate]]
[[File:Donkey Saw Rating Plate.jpeg|thumb|left|400px|Rating Plate]]
Feed from a 16amp 3 Phase supply
Feed from a 16amp 3 Phase supply
<br clear=all>
<br clear=all>

Revision as of 09:05, 23 February 2019

Donkey Saw
Nottinghack Tools Rapidor donkey saw.jpg
Manufacturer Rapidor
Location Metalworking Area
Team Metalworking
Induction Required No
Booking {{{booking}}}
Status Defunct
Tools:   all pageslistPower ToolsBroken tools     {{}}

This donkey saw/ power hacksaw can be used to cut through thick sections of metal that would otherwise be impractical to cut by hand.

Cutting fluid nozzle placement

The correct placement for the cutting fluid nozzle is pointing down over the blade about 1-2 inch behind the work being cut.
The idea is to cool the blade and have it pull the fluid into the cut on the work
Donkey Saw Cooling 1.jpgDonkey Saw Cooling 2.jpg

Fluid should not be splashing into the drip tray in large quantity!
Donkey Saw incorrect cooling.jpg

When too much coolant gets spilled into the drip tray, it can be topped up with a small quantity of fresh water (add just sufficient to re-start the flow).

When the mix gets too diluted, it can be topped up with a strong mix (to allow ongoing dilution) of cutting fluid and water as part of the general maintenance process by the tools team.


Rating Plate

Feed from a 16amp 3 Phase supply