Difference between revisions of "Robot Badge"
|Line 166:||Line 166:|
Revision as of 12:35, 13 June 2019
These are notes and files relating to the 'Learn To Solder' Robot Badge. This badge kit has been produced to use at events as a simple soldering exercise and promote the hackspace. This badge was based upon a simple flashing LED badge that was seen at UK Maker Faire 2011 in Newcastle. This robot shaped badge was designed by Matt Little based on an idea by Rob Keating from PCB manufacturers, Beta Layout. Beta Layout produced a number of batches of these PCBs for Nottingham Hackspace.
- Spread out the parts: PCB, LED, Battery Holder, Battery, Pin, Clasp
- Apply a small amount of sodler to the battery pad. This raises the pad so it makes a good connection to the battery
- Put the PCB on the edge of a table and place the pin through. Solder the pin
- Solder the LED. Make sure the LED is the correct orientation. The long lead is positive and fits in the hole with the + symbol.
- Push the battery clip into the back of the PCB. Make sure the open side is facing downwards so the battery can fit in.
- Push the battery in with the + side face up. And hopefully you should have a flashing badge...
SMD Robot Badge
Parts List - Simple
The simple version of the badge is just an LED wired derectly with a battery. A colour changing LED is used to make it a bit more interesting.
|3V Battery||CR2032||eBay 1 Cost: £10 for 100
eBay 2 Cost: £10 for 100
|Battery clip||To hold above||Rapid: 18-3585 Cost: £0.312 100+
Farnell: 908654 Cost: £0.442 100+
Digikey UK: BK-888-ND Cost: £0.1674 100+
|LED||5mm colour chaging||Rapid: 55-1906 £0.4326 100+
eBay 1: Cost: £6.99 for 30
eBay 2: Cost: £3.50 for 30
|Pin||13mm panel pin||Stones hardware £0.56 for box (100pcs)
eBay 1 £1.60 for box
|Badge Clip||To fit above pin||eBay 1: Cost: £4.99 for 100
eBay 2: Cost: £3 for 100
Parts List - SMD
The SMD version of the badge was designed for more advanced users so they can learn to do surface mount soldering or use an SMD oven. The circuit is a Flip Flop Two Transistor Flasher. The schematic diagram is here: ADD a PHOTO/PDF HERE
|Capacitor||C1, C2||Control flash rate. 10uf used. Size: 1206.||RS: 740-7546|
|Resistor||R2, R3||Control Flash Rate. 100k used. Size: 1206||Rapid: 72-1437|
|Resistor||R1, R4||Limit LED current. 0 ohm with 3V battery. Size: 1206||Rapid: 72-1207|
|Transistor||Q1, Q2||NPN type. S0323. BC817W used.||Farnell: 2114873|
|LED||D3, D4||Red or Green. Not enough voltage for Blue/White. Size: 1206||Green. RS: 466 3908|
The PCB was designed using KiCAD - an open source PCB design package.