Cookies help us deliver our services. By using our services, you agree to our use of cookies.OK

Difference between revisions of "Silhouette Cameo"

(→‎Resources: * [ Guide to different blades (Silhouette School)])
Line 5: Line 5:
|model= Cameo 3
|model= Cameo 3
|obtained=Purchased through [[Cameo_Pledge|Pledge Drive]] early 2018
|obtained=Purchased through [[Cameo_Pledge|Pledge Drive]] early 2018
|location=Textiles Workshop
|location=Craft Room
|team=Craft & Textiles
|team=Craft & Textiles

Revision as of 00:49, 24 October 2021

Silhouette Cameo
Tool Silhouette Cameo.jpg
Manufacturer Silhouette
Model Cameo 3
Obtained Purchased through Pledge Drive early 2018
Location Craft Room
Team Craft & Textiles
Induction Required No
Booking {{{booking}}}
Status Defunct
Tools:   all pageslistPower ToolsBroken tools     {{}}

The Silhouette Cameo is a computer controlled cutter that can cut through vinyl, card, fabric and paper up to 12 inches wide. The Cameo supports automated cutting heads, has two carriages (so draw and cut operations can be done in one pass) plus registration marks for aligment, and more.

It was purchased through a pledge drive in early 2018.



Induction Notes

non-induction machine.

Machine Setup

It is worth keeping the backing sheet for the cutting mat. It stops you from needing to refresh the spray mount so often when the glue dries out.

When spraying with spray mount it's worth covering the non-sticky sections of the mat with masking tape, else the rollers of the machine pick up the glue which can effect how well it works.

Its generally worth using the cutting mat most of the time even if you are cutting a full width bit of vinyl. Unless you are a wizard at getting your material perfectly straight the rollers tend towards eating it.

The blade depth doesn't need to be stuck out lots and lots if you are cutting a thin material. For vinyl, paper and thing card usually setting 2 is sufficient.

Before cutting its worth removing the blade to check it doesn't have a build up of fluff round the razor. When cleaning it beware cutting hazards.

Make sure the blade is seated back where it was when you replace it.

Using the PC software

Special attention areas

some suggestions were offered by Arthur Moore during the pledge drive


See also