Difference between revisions of "YooCNC"
Jump to navigation
Jump to search
m |
|||
| Line 8: | Line 8: | ||
To use the CNC you need to boot into Ubuntu (default choice) | To use the CNC you need to boot into Ubuntu (default choice) | ||
| − | Password is | + | Password is yoocnc6040 |
Posible that controller board has room for limit switches (net research) even though lacking connector on the back. need to take a look inside. --[[User:Lwk|'RepRap' Matt]] 18:26, 30 October 2011 (EST) | Posible that controller board has room for limit switches (net research) even though lacking connector on the back. need to take a look inside. --[[User:Lwk|'RepRap' Matt]] 18:26, 30 October 2011 (EST) | ||
Need to read the manual and configure EMC2 --[[User:Lwk|'RepRap' Matt]] | Need to read the manual and configure EMC2 --[[User:Lwk|'RepRap' Matt]] | ||
| + | |||
| + | chuck is a ER11 type | ||
| + | |||
| + | currently fitted with a 1/8" collet | ||
Revision as of 23:36, 16 November 2011
We currently have a YooCNC mill on loan.
Appears to be a 6040 CNC, rather generic Chinese Mill, shipped with a few different controller boards/steppers/spindles.
It's setup in the workshop and has a dedicated pc named YooCNC on the network, it's dual boot with XP and Ubuntu/EMC2.
To use the CNC you need to boot into Ubuntu (default choice)
Password is yoocnc6040
Posible that controller board has room for limit switches (net research) even though lacking connector on the back. need to take a look inside. --'RepRap' Matt 18:26, 30 October 2011 (EST)
Need to read the manual and configure EMC2 --'RepRap' Matt
chuck is a ER11 type
currently fitted with a 1/8" collet