View source for Dan's Plumb Bob

{{Project
|image=File:DanS Plumb Bob 2.jpg
|name=Plumb bob
|primary=[[User:Danspencer101|Danspencer101]]
|created=15/06/2019
|completeddate=15/06/2019
|dormantdate=
|version=
|members=
|status=Complete
|type=member
|livestatus=
|qrmode=1
}}

I had a go at practicing the task described on the [[Myford_lathe/Inductions|Myford Induction]] page. Came out quite nicely.

I used approximately 100mm of 25mm diameter aluminium bar to make this. 

<gallery mode=packed heights=300px>
File:DanS Plumb Bob 1.jpg
File:DanS Plumb Bob 2.jpg
</gallery>
{{clear}}
==Technical Drawings==
I had a go at doing some technical drawings in [[Fusion 360]] for this assembly. Nothing too technical and not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. Note that my plumb bob doesn't match these drawings, I used a shallower taper angle. 

<gallery mode=slideshow heights=300px>
File:Plumb Bob Drawing v4-1.jpg
File:Plumb Bob Drawing v4-2.jpg|Also available as a [[:File:Plumb Bob Drawing v4.pdf|PDF File]]
File:Plumb Bob Drawing v4-3.jpg
</gallery>