Resin Calibration Charts
A page to collate resin calibration charts for the Anycubic Photon 3D printer.
It is possible to print a Calibration Chart for a specific layer height with your resin to find a good starting point.
This process requires changing the printer's settings, printing one or more charts, and then restoring the previous settings. **Please make sure you are confident that you can restore the standard settings before starting this process.**
As an opaque resin the AnyCubic Orange appears to require a much longer cure time (20s at 20 microns) and is very sensitive to bed levelling.
Test cards for AnyCubic Translucent Yellow resin will be uploaded when I am back in the space to photograph them.
Currently the test cards are being kept near the printer for ease of reference.
Reading the Test Cards
The numbers at the bottom of the card are the exposure time for that column in multiples of 2 seconds. The features in the column start at 1mm and decrease by 0.1mm with each row. After 0.1mm the features decrease by 0.01mm per row. The resolution of the printer is 0.045mm so the lower four rows are not expected to be correct.
Start from top and locate first well formed circle column Move to bottom last visible Circle Move right untill the circle starts to clog Backtrack one colum That's your sweetspot