Difference between revisions of "User:Asj/Notes about laser cutting solder stencils"
< User:Asj
Jump to navigation
Jump to search
(No difference)
|
Latest revision as of 21:29, 20 May 2024
Most pads are ok - perhaps a bit large.
- Change the pad clearance in Lightburn
- File -> Board Setup -> Solder Mask Paste
- "Solder paste absolute clearance" -> -0.09mm
- Configure Light burn to engrave at
- 100mm/s at 28%
- Line interval of 0.02mm
I like to soak a piece of paper in water and put it below the mylar. This helps reduce burning and warping