Dan's Plumb Bob: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 18: | Line 18: | ||
I used approximately 100mm of 25mm diameter aluminium bar to make this. | I used approximately 100mm of 25mm diameter aluminium bar to make this. | ||
<gallery mode=packed | <gallery mode=packed heights=300px> | ||
File:DanS Plumb Bob 1.jpg | File:DanS Plumb Bob 1.jpg | ||
File:DanS Plumb Bob 2.jpg | File:DanS Plumb Bob 2.jpg | ||
Latest revision as of 23:56, 7 July 2019
| Plumb bob | |
|---|---|
 | |
| Primary Contact | Danspencer101 |
| Created | 15/06/2019 |
| Completed | 15/06/2019 |
| Status | Complete |
| Type | Members Project |
I had a go at practicing the task described on the Myford Induction page. Came out quite nicely.
I used approximately 100mm of 25mm diameter aluminium bar to make this.
Technical Drawings
I had a go at doing some technical drawings in Fusion 360 for this assembly. Nothing too technical and not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. Note that my plumb bob doesn't match these drawings, I used a shallower taper angle.
-
-
Also available as a PDF File -
