Dan's Plumb Bob: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 18: | Line 18: | ||
I used approximately 100mm of 25mm diameter aluminium bar to make this. | I used approximately 100mm of 25mm diameter aluminium bar to make this. | ||
<gallery mode=packed | <gallery mode=packed widths=400px> | ||
File:DanS Plumb Bob 1.jpg | File:DanS Plumb Bob 1.jpg | ||
File:DanS Plumb Bob 2.jpg | File:DanS Plumb Bob 2.jpg | ||
</gallery | </gallery> | ||
==Technical Drawings== | |||
I had a go at doing some technical drawings in [[Fusion 360]] for this assembly. Nothing too technical and Not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. | |||
<gallery mode=packed widths=400px> | |||
File:Plumb Bob Drawing v4-1.jpg | |||
File:Plumb Bob Drawing v4-2.jpg|Also available as a [[:File:Plumb Bob Drawing v4.pdf|PDF File]] | |||
File:Plumb Bob Drawing v4-3.jpg | |||
</gallery> | |||
Revision as of 00:44, 18 June 2019
| Plumb bob | |
|---|---|
 | |
| Primary Contact | Danspencer101 |
| Created | 15/06/2019 |
| Completed | 15/06/2019 |
| Status | Complete |
| Type | Members Project |
| QR code | |
I had a go at practicing the task described on the Myford Induction page. Came out quite nicely.
I used approximately 100mm of 25mm diameter aluminium bar to make this.
Technical Drawings
I had a go at doing some technical drawings in Fusion 360 for this assembly. Nothing too technical and Not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to.
-
-
Also available as a PDF File -
