Yrs3d: Difference between revisions
Jump to navigation
Jump to search
Created page with "== YRS 3D Printer Status and Log == X-end idler was broken New part printed X Smooth rods too long (length for non LM8 X ends) Cut down by 15mm to 435mm X assembly built an..." |
No edit summary |
||
| Line 33: | Line 33: | ||
=== Calibration / fine alignment === | === Calibration / fine alignment === | ||
= Useful Links = | |||
[http://reprap.org/wiki/Prusa_Mendel_Build_Manual Build Manual] | |||
Revision as of 22:14, 24 December 2013
YRS 3D Printer Status and Log
X-end idler was broken New part printed
X Smooth rods too long (length for non LM8 X ends) Cut down by 15mm to 435mm
X assembly built and fitted
Z motors added with coupling rods - motors not screwed in place notes on web seem to indicate that it may be better to not screw these down but to use tie wraps to hold them in place and redude out of alignment rough spots/vibration.
X carriage movement a bit stiff, a couple of tries using washers/spacers to make it run better it now moves reasonably, further adjustment may be needed once the electronics/motors are connected and under power testing can be done.