Laser cutter/Inductions/Program: Difference between revisions
< Laser cutter | Inductions
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
You '''do not''' need to follow this step by step, but should include all of the material when running an induction. Inductions will use up your laser time initially. To get this time back onto your card, please '''some steps to go here''' | You '''do not''' need to follow this step by step, but should include all of the material when running an induction. Inductions will use up your laser time initially. To get this time back onto your card, please '''some steps to go here''' | ||
==Setting up | ==Setting up safety== | ||
* RFID | * RFID | ||
* Is everything on? | * Is everything on? | ||
* Things to be aware of | |||
** z-axis | |||
** emergency stop - make sure they use it | |||
** control panel - know who is using it | |||
== | ==Control Panel== | ||
==Setting up your XYZ axis | * Start/Pause | ||
* Stop | |||
* Datum | |||
* Test area | |||
==Introduction to LaserCut== | |||
==Setting up your XYZ axis== | |||
==Engraving== | ==Engraving== | ||
Revision as of 17:38, 29 May 2014
The induction program is there to ensure a new user can use the laser cutter safely and effectively.
You do not need to follow this step by step, but should include all of the material when running an induction. Inductions will use up your laser time initially. To get this time back onto your card, please some steps to go here
Setting up safety
- RFID
- Is everything on?
- Things to be aware of
- z-axis
- emergency stop - make sure they use it
- control panel - know who is using it
Control Panel
- Start/Pause
- Stop
- Datum
- Test area