Superbox CNC Router/Maintenance
< Superbox CNC Router
Jump to navigation
Jump to search
Revision as of 23:42, 26 May 2019 by Danspencer101 (talk | contribs) (Created page with "==Replacing the Spindle Fuse== On several occasions, the spindle fuse has blown. If this is the case, there will be an audible relay noise clicking in the control box when the...")
Replacing the Spindle Fuse
On several occasions, the spindle fuse has blown. If this is the case, there will be an audible relay noise clicking in the control box when the spindle is turned on through G-Code but nothing will happen at the spindle.
The procedure to replace the fuse is fairly simple. In the video shown below the fuse used is: T3.15A 250V.
Note: Ensure the control box is completely disconnected from mains power before working on the internals