Dan's Plumb Bob

Plumb bob
Primary Contact	Danspencer101
Created	15/06/2019
Completed	15/06/2019
Dormant
Version
Members
Manufacturer	{{{manufacturer}}}
Model	{{{model}}}
Location	[[{{{location}}}]]
GitHub / Repo	{{{repo}}}
Status	Complete
Type	Members Project
Live Status
QR code

I had a go at practicing the task described on the Myford Induction page. Came out quite nicely.

I used approximately 100mm of 25mm diameter aluminium bar to make this.

• 
• 

Technical Drawings

I had a go at doing some technical drawings in Fusion 360 for this assembly. Nothing too technical and not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. Note that my plumb bob doesn't match these drawings, I used a shallower taper angle.

• 
• 
  Also available as a PDF File
•