Bat Box

Bat Box
Primary Contact	Danspencer101
Created	23/06/2019
Completed	23/06/2019
Dormant
Version
Members
Manufacturer	{{{manufacturer}}}
Model	{{{model}}}
Location	[[{{{location}}}]]
GitHub / Repo	{{{repo}}}
Status	Complete
Type	Workshop Activity
Live Status
QR code

I had a go at making a Bat Box from plans on the Nottinghamshire Wildlife Trust website.

The wood (6" x 1" x 1200mm) was obtained from Harlow Bros. It can be brought in 4m-ish lengths for around £7. They cut it down for free into three manageable lengths that would fit into my car.

• 
  Plans from the Wildlife Trust Website

Method

The method of manufacture is as follows:

1. Mark out the wood with a marker pen or pencil
2. Table Saw to do the majority of the cuts.
3. For the side pieces with angled tops, I used the Sliding Mitre Saw.
4. Hand Miter Saw to do the 1mm deep bat ladder on the back piece.
5. Impact Driver to screw everything together.
6. Laser Cutter to engrave logos.
7. Seal gaps with wood glue.

Gallery

• 
  Marking out the cuts
• 
  Marking out the cuts
• 
  The finished bat box
• 
  The finished bat box

Workshop July 2019

<gallery mode=packed-hover heights=300px> File:BATBOX1.PNG File:BATBOX2.PNG <gallery>

Also available as a PDF File:BatBox Workshop.pdf