Difference between revisions of "Dan's Plumb Bob"
Jump to navigation
Jump to search
(Created page with "{{Project |image=File:DanS Plumb Bob 2.jpg |name=Plumb bob |primary=Danspencer101 |created=15/06/2019 |completeddate=15/06/2019 |dormantdate= |version=...") |
|||
| (8 intermediate revisions by the same user not shown) | |||
| Line 18: | Line 18: | ||
I used approximately 100mm of 25mm diameter aluminium bar to make this. | I used approximately 100mm of 25mm diameter aluminium bar to make this. | ||
| − | <gallery> | + | <gallery mode=packed heights=300px> |
| + | File:DanS Plumb Bob 1.jpg | ||
File:DanS Plumb Bob 2.jpg | File:DanS Plumb Bob 2.jpg | ||
| − | File: | + | </gallery> |
| − | </gallery | + | {{clear}} |
| + | ==Technical Drawings== | ||
| + | I had a go at doing some technical drawings in [[Fusion 360]] for this assembly. Nothing too technical and not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. Note that my plumb bob doesn't match these drawings, I used a shallower taper angle. | ||
| + | |||
| + | <gallery mode=slideshow heights=300px> | ||
| + | File:Plumb Bob Drawing v4-1.jpg | ||
| + | File:Plumb Bob Drawing v4-2.jpg|Also available as a [[:File:Plumb Bob Drawing v4.pdf|PDF File]] | ||
| + | File:Plumb Bob Drawing v4-3.jpg | ||
| + | </gallery> | ||
Latest revision as of 23:56, 7 July 2019
| Plumb bob | |
|---|---|
 | |
| Primary Contact | Danspencer101 |
| Created | 15/06/2019 |
| Completed | 15/06/2019 |
| Status | Complete |
| Type | Members Project |
| QR code | |
I had a go at practicing the task described on the Myford Induction page. Came out quite nicely.
I used approximately 100mm of 25mm diameter aluminium bar to make this.
Technical Drawings
I had a go at doing some technical drawings in Fusion 360 for this assembly. Nothing too technical and not to any particular standard as I'm still finding my feet with the software. Its a little different to Siemens NX that I'm used to. Note that my plumb bob doesn't match these drawings, I used a shallower taper angle.
Also available as a PDF File
