Difference between revisions of "Oscillating Bobbin Sander"
(bare bones, scan of manual to be added) |
|||
Line 1: | Line 1: | ||
{{Tool | {{Tool | ||
− | |image=File: | + | |image=File:Oscilating_Bobin_Sander.png |
− | |||
|manufacturer=Axminster Craft | |manufacturer=Axminster Craft | ||
|model=Earlier version of [https://www.axminster.co.uk/axminster-craft-ac140oss-bobbin-sander-105109 ac140oss] | |model=Earlier version of [https://www.axminster.co.uk/axminster-craft-ac140oss-bobbin-sander-105109 ac140oss] | ||
Line 22: | Line 21: | ||
The on-switch is located on the front, under the off switch flap, undo the clip and lift the flap. | The on-switch is located on the front, under the off switch flap, undo the clip and lift the flap. | ||
Instructions on how to use and maintain the tool are in the manual attached to the wall. | Instructions on how to use and maintain the tool are in the manual attached to the wall. | ||
− | The spindles can be changed to | + | The spindles can be changed to accommodate different radius profiles |
+ | |||
+ | [[File:Oscilating Bobin Sander On.png|200px|frameless]] | ||
==Use dust extraction when sanding== | ==Use dust extraction when sanding== |
Revision as of 10:45, 10 June 2019
Oscillating Bobbin Sander | |
---|---|
Manufacturer | Axminster Craft |
Model | Earlier version of ac140oss |
Obtained | Hackspace Owned (May 2019) |
Location | Dusty Area |
Team | Woodworking |
Induction Required | No |
Tools: all pages • list • Power Tools • Broken tools {{}} |
![]() |
This page is a stub. You can help by expanding it! This page is included in the list of stub pages. |
Please improve this page by adding a photo. Click to upload an image, help with using images can be found here. The talk page may contain suggestions about suitable images. |
What does it do
The Oscillating Bobin Sander is intended, but not limited to, sanding an internal radius on timber or other compatible materials. The spindle rotates and oscillates up and down, it is possible to tilt that table to achieve a bevelled edge profile on your work.
How to use it
The manual is pinned to the wall behind the device. The on-switch is located on the front, under the off switch flap, undo the clip and lift the flap. Instructions on how to use and maintain the tool are in the manual attached to the wall. The spindles can be changed to accommodate different radius profiles
Use dust extraction when sanding
At the moment of writing the unit does not have a dedicated extraction system, make sure the exhaust is connected at the back of the table to the extraction system currently shared with other equipment (the hose should just pull off and connect)
The Hackspaces Super 7 has been dated to around January 1973.
Pledges