Air Quality Monitoring: Difference between revisions
No edit summary |
No edit summary |
||
| Line 21: | Line 21: | ||
! Location !! Measurements !! Status | ! Location !! Measurements !! Status | ||
|- | |- | ||
| Comfy Area || VOC, CO2 || | | Comfy Area || VOC, CO2 || Built | ||
|- | |- | ||
| Studio || VOC, CO2 || {{Done}} | | Studio || VOC, CO2 || {{Done}} | ||
| Line 35: | Line 35: | ||
| Electronics / 3D Printing || VOC, CO2, Particle || Built | | Electronics / 3D Printing || VOC, CO2, Particle || Built | ||
|- | |- | ||
| Blue Room || VOC, CO2 || | | Blue Room || VOC, CO2 || Built | ||
|- | |- | ||
| | | Art Room || VOC, CO2 || Built | ||
|} | |} | ||
Revision as of 21:49, 9 February 2026
| Air Quality Monitoring | |
|---|---|
 | |
| Primary Contact | Asj |
| Created | 01/01/2026 |
| Status | Active |
| Type | Hackspace Infrastructure |
The air quality monitoring was funded via the Air Quality Monitoring Pledge Drive. All monitors report CO2 and VOC index. In a few places the monitors also have PMSA003 sensors for PM1.0, PM2.5, PM10.0. These measurements are (will be) pushed to MQTT to the topic nh/air, where they are then ingested into Prometheus for visualisation via Grafana.
Current Status
The boards are gradually being built. Steve is designing an enclosure for them. We should have a few up and running soon.
| Location | Measurements | Status |
|---|---|---|
| Comfy Area | VOC, CO2 | Built |
| Studio | VOC, CO2 |  Done
|
| Craft Room | VOC, CO2 | |
| Workshop | VOC, CO2, Particle | Built |
| Dusty | VOC, CO2, Particle | Done
|
| Metalworking | VOC, CO2 | |
| Electronics / 3D Printing | VOC, CO2, Particle | Built |
| Blue Room | VOC, CO2 | Built |
| Art Room | VOC, CO2 | Built |
Hardware Description
The board is based around an Atmega 328p and WizNet W5500 Ethernet controller. There's a small buck supply to make powering the board more flexible. The VOC sensor used is a SGP40, and CO2 is reported with a SCD41. For boards which also measure air particles, they have a PMSA003 onboard. Out of curiosity and to help debugging, each board also has a INA219A chip and 0.1 ohm shunt. This allows the board to monitor its own power consumption.