Difference between revisions of "New CNC PC Pledge"
(→List of pledges)
|Line 76:||Line 76:|
[[Category:Pledge Drives ]]
Latest revision as of 18:18, 8 May 2019
The Current PC running the CNC Mill is a Pentium 4 based system. It crashes a lot, is dated, sluggish and not nice to use.
Anyone who has used it will tell you this.
The aim of this pledge drive is to refresh the hardware with something much faster that will make the CNC machine much more responsive and nicer to use. Refreshing the hardware also gives us an upgrade path to a Mesa card should we decide to buy one in the future. The software setup will remain identical to the current system.
Current PC Baseline
This is what the new hardware needs to beat. Latency is more important that raw power hence why we are not pledging for an i7 or similar based pc.
A new PC will be built from scratch. The PC will be based around the J3455 Motherboard + CPU combo. It has got some good recommendations on the LinuxCNC forums.
- ASRock J3455B-ITX 2DDR3(SOD)/2S3/GL M-ITX Mainboard (Amazon)
- BeQuiet 300 W SFX Power Supply Unit (Amazon)
- Aerocool CS-101 Slim M-ATX Computer Case
- Kingston HX316LS9IB DDR3L 4GB
- PNY 120GB CS900 SSD
Total cost: £182.28
Any extra funds will be put towards a Touch Screen monitor or a new set of step clamps.
List of pledges
Please post on the google group mailing list if you really, truly have forgotten your HMS password and need to have someone else to update this.
Please pay with the reference PLEDGECNCPC-XX where XX is your initials
|Who||How Much||Paid?||Method Paid|
|Dan Spencer||£30||Yes||Bank Transfer (confirmed)|
|Ian D||£25||Yes||Bank transfer (confirmed)|
|Jim Taylor||£15||Yes||Bank Transfer (confirmed)|
|Jon H||£15||Yes||BACS (with membership reference number) (confirmed)|
|Bob Wood||£5||Yes||BACS (confirmed)|
|Sam Roberts||£10||Yes||BACS (confirmed)|
|Paul M||£10||Yes||-- (confirmed)|
|Lee Hutchison||£10||Yes||BACS (confirmed)|
|James S||£20||Yes||BACS (confirmed)|
|Alex S||£33||Yes||BACS (PLEDGECNCPC-AS) (confirmed)|
The PC has been installed and is ready to use. If you have any issues with it, Please feedback in the #CNC Slack group.
The installation process has been documented on Trello; There may still be some fine tuning to do but the computer is safe to use.