Reprap Prusa

From Nottinghack Wiki
Revision as of 08:42, 23 May 2011 by Msemtd (talk | contribs)
Jump to navigation Jump to search

Main source of information: the Prusa page at --

Build instructions: File:Prusa Mendel Visual Instructions (Mininum Resolution).pdf

BOM: --

Bill of Materials: Non-Printed Parts
Quantity Description Type Comments
83 M8 nut Fastener Buy a 100-pack to be on the safe side. (NOT GOT)
93 M8 washer Fastener Buy a 100-pack to be on the safe side. (GOT)
6 M8×30 mudguard / fender washers Fastener (NOT GOT)
2 M4×20 bolt Fastener (GOT)
2 M4 nut Fastener (GOT)
2 M4 washer Fastener (GOT)
22 M3×10 bolt Fastener (GOT)
16 M3×25 bolt Fastener Or eight M3×25 bolt plus eight M3x20 bolts, see §8 steps 5 and 13 for details. (GOT all options)
4 M3×40 bolt Fastener (GOT)
70 M3 washer Fastener (GOT)
40 M3 nut Fastener Eight optionally locknut / stop nut / nyloc (GOT)
2 M3 grub screw / set screw Fastener (GOT see Matt)
3 608 roller skate / inline skate / skateboard bearing Bearings (GOT)
4 ballpoint pen springs Spring (GOT - various springs at space - others available)
6 M8×370mm Threaded rod Three per side (GOT)
4 M8×294mm Threaded rod Front / rear (GOT)
3 M8×440mm Threaded rod Top / bottom (GOT)
2 M8×210mm Threaded rod Z-leadscrew (GOT)
1 M8×50mm Threaded rod Or bolt for X idler (GOT)
2 8mm×420mm Smooth rod
2 8mm×406mm Smooth rod Y-bar
2 8mm×350mm Smooth rod Z-bar
1 225mm×225mm print top plate Thick Sheet
1 140mm×225mm print bottom plate Thick Sheet
1 840mm×5mm T5 pitch timing belt Belt
1 1380mm×5mm T5 pitch timing belt Belt
5 NEMA 17 bipolar stepper motor Stepper
50 small cable binder / ziptie Misc
1 Wade's Geared Extruder Or any other compatible extruder
1 Electronics + endstops This can be RAMPS, Gen6, Gen3, or anything else compatible
3 30mm×10mm Optoflags Thin Sheet If using opto endstops
2 8mm ID spring Spring If using opto endstops (GOT - various springs at space - others available)

We have all the M8 rod, the M8 washers, all the M3 and M4 parts.