Pantograph Engraving Machine

Pantograph Engraving Machine
Manufacturer	Rank-Taylor-Hobson
Model	Model D
AKA	{{{aka}}}
Obtained	Pledge Drive (01/02/2019)
Location	Metalworking Area
Team	Metalworking
Induction Required	No
Booking	{{{booking}}}
Status	Defunct
Tools:   all pages • list • Power Tools • Broken tools     {{}}

Images

• 
  Engraving Machine Front View
• 
  Picture of Existing Gravograph Templates
• 
  Side View. Note for scale, the machine stands about 4 feet tall

Manual

The manual can be found here: Media:Taylor_Hobson_Engraver_manual.pdf

Scale Adjustment

The scale must be adjusted at 3 points. They must all be on the same number, or the engraving will come out slanted. The diagram below indicates the 3 points.

Cutter Grinder

There is a cutter grinder that goes with this machine, that grinds the D bit cutters to the special form required. Do not use this grinder for anything else not stated in the user manual. Damage to you or the machine will occur, especially if you are caught. The manual for the cutter grinder is here: Media:Engraver_cutter_grinder_manual.pdf

Letter Templates

The letter templates are stored in the grey drawer under the bench between the Engraver and the mini mill, labelled "Engraver Letters"

Power

Rating Plate

Fed from a 16amp 3 Phase supply

The Pantograph Engraving Machine shares a 3 phase socket with the Bridgeport Mill. It is located on the ceiling. The Bridgeport Mill should be plugged in by default.